No products
Catalog
Subcategories
Select the type of spider/chainrings
This spacer kit will adjust your Aldhu/Vegast spindle length to the BB standard. It's available for road or offset
Compatible with: Aldhu 3d+ left and right arms Vegast 30mm left and righ arms
Compatible with: Aldhu 24 left arms Vegast 24mm left arms
Compatible with: Aldhu 24 right arms (drive side) Vegast 24mm right arms (drive side)
This spacer kit is reducing the length of standard bolts and allows to mount a Rotor single chainring on a Shimano crank or Rotor spider. Bolt compatibility: Rotor 6800/9000/8000/9100 bolt kit.
This part is adjusting the lateral play of the arms. You can buy one if your's is damaged. Please select the good spindle version of your crank. It's compatible with Aldhu and Vegast cran arms.
One spacer for 30mm spindles (Aldhu 3d+, Vegast, 3D+, Flow, 3d30, Inpower, 2Inpower). Original Rotor part. Check your needs and buy the correct sizes.
This tool mounts Rotor UBB on frames. It's not sold with Rotor UBB and you'll need it if you mount your BB by yourself. It's also compatible with BSA30 and ITA30 Rotor
This insert will replace the insert of Rotor Garmin mounts. Rotor original part.
This pin reduces the risk to have the chain locked between the outer ring and the crank arm.
Bolt and adjuster. Compatible with Rotor 3d+ cranks.
This part will allow you to lowering or rising the front derailleur.Might be used with 46-48T and 56-58T chainrings
Aero crown is an aero cover for your Rotor INspider powermeter. Check the video below to understand how it works.
Transform Aldhu/Vegast 30mm arms in a track crankset.
This tool will tighten the spider/spidering on your Rotor Inpower or 2Inpower DM crank. You need to use also a Shimano BSA tool to tighten.
This replacement screw is for 2INpower left arm only.
Replacement seals for your BB30 bearings. Seals are required for all Rotor 30mm cranks but they are always delivered with the bearings purchased.